Layer 3 Functions; The "Show" Commands; Show Ip Protocol - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions

This part contains the sections that describe the following:
● OSPFv2 (IPv4)
● OSPFv3 (IPv6)
● RIPv2 (IPv4)
● RIPng (IPv6)
● VRRP (IPv4)
● VRRPv3 (IPv4/IPv6)
● Route maps (IPv4/IPv6)
● NAT (IPv4)
● PIM (IPv4)
The layer 3 functions describe the routing properties of the device. These are not normally
included in the basic device and if necessary must be enabled or released extra.
9.1

The "show" commands

This section describes commands with which you display various settings.
9.1.1

show ip protocol

Description
This command shows the current settings of the activated routing protocols.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
9
511