Match Metric - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.8 Route maps (IPv4 / IPv6)

The parameters have the following meaning:

interface-type

interface-id

The filter for the interface is deleted.

Further notes

You create a filter for an interface with the

You change to the Route maps configuration mode with the command

You display the setting and other information with the

match metric

With this command, you specify whether or not the routing information for a route map is

filtered based on the value of the metric.

This command is available only with layer 3.

You are now in the Route maps configuration mode.

The command prompt is as follows:

cli(config-rmap-$$$)#

Call up the command with the following parameters:

match metric <value(0-0xffffff)>

Keyword for a VLAN

Keyword for a VLAN connection

Type or speed of the interface

Module no. and port no. of the

Range of values / note

Enter a valid interface.

match interface

show route-map

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11