Clear Ipv6 Dhcp Relay Statistics - Siemens SCALANCE XM-400 Configuration Manual

Parameter
vlan-id
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter, the entries are displayed for all available interfaces.
Result
The configuration settings are displayed.
Further notes
You enable the DHCPv6 relay agent function with the
7.7.2

clear ipv6 dhcp relay statistics

Description
With this command, you reset the counters.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
clear ipv6 dhcp relay statistics [interface {vlan <VlanId(1-4094)> |<interface-type>
<interface-id>}]
The parameters have the following meaning:
Parameter
interface
vlan
vlan-id
interface-
type
interface-id
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Description
Shows that an interface description follows
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Network protocols
7.7 DHCPv6 Relay Agent (IPv6)
Range of values / note
1 ... 4094
Enter a valid interface.
command.
ipv6 dhcp relay.
Range of values / note
-
-
1 ... 4094
Enter a valid interface.
377