No Vrrp Preempt - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

no vrrp preempt

With this command, you specify that a router cannot take over the master role from a router

with lower priority. The master role is adopted only if the current master router fails.

This command is available only with layer 3.

● An IP address is assigned to the virtual router.

● You are in the VRRP3 Interface configuration mode.

The command prompt is as follows:

cli(config-vrrp-v3-if-$$$)#

Call up the command with the following parameters:

no vrrp <vrid(1-255)> preempt

The parameter has the following meaning:

The function is disabled.

Further notes

You configure a VRRP3 interface with the

You assign IP addresses to a virtual router with the

You enable the function with the

You display the status of the function with the

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

ID of the virtual router

vrrp preempt

9.5 VRRPv3 (IPv4 / IPv6)

Range of values / note

vrrp associated-ip

show vrrp3 interface

Layer 3 functions