Match Tag - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.8 Route maps (IPv4 / IPv6)

match tag

With this command, you specify whether or not the routing information for a route map is

filtered based on tags.

This command is available only with layer 3.

You are now in the Route maps configuration mode.

The command prompt is as follows:

cli(config-rmap-$$$)#

Call up the command with the following parameters:

match tag <value (1-0xffffff)>

The parameter has the following meaning:

The filter for a tag is created.

Further notes

You delete the filter for a tag with the

You change to the Route maps configuration mode with the command

You display the setting and other information with the

Value of the tag

Range of values / note

1 ... 0xffffff

You can enter the value in decimal or

hexadecimal.

no match tag

show route-map

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11