No Ip Ospf Dead-Interval - Siemens SCALANCE XM-400 Configuration Manual

Result
The interval is specified.
Further notes
You delete the interval with the
You show the configuration of the OSPF interface with the
command.
9.2.4.8

no ip ospf dead-interval

Description
With this command, you delete the interval.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ip ospf dead-interval
Result
The interval is deleted.
Further notes
You specify the interval with the
You show the configuration of the OSPF interface with the
command.
You configure the router port with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
no ip ospf dead-interval
ip ospf dead-interval
command.
no switchport
Layer 3 functions
9.2 OSPFv2 (IPv4)
command.
show ip ospf interface
command.
show ip ospf interface
557