8.7 Multicast; The "Show" Commands; Show Multicast-Block Config - Siemens SCALANCE XM-400 Configuration Manual

8.7 Multicast
The commands in this section configure the procedures for handling Multicast frames.
The commands allow the following:
● Configuration of groups
● IGMP/MLD
● GMRP
● Blocking unknown Multicast frames.
With the "show" commands, you can display the configuration data.
8.7.1

The "show" commands

This section describes commands with which you display various settings.
8.7.1.1

show multicast-block config

Description
This command shows the multicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show multicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all ports are displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
Description
Keyword for a port description
Type of interface
Module no. and port no. of the interface
Layer 2 management protocols

8.7 Multicast

Range of values / note
-
Enter a valid interface
491