Asbr Router - Siemens SCALANCE XM-400 Configuration Manual

Requirement
The commands are available if the following requirements are met:
● The device supports the routing function.
● The routing function is enabled.
9.2.3.1

ASBR Router

Description
With his command, you specify that the router is an Autonomous System Boundary Router
(ASBR).
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call the command without parameters:
ASBR Router
Result
The autonomous system boundary router is enabled.
Further notes
You disable the autonomous system boundary router with the
You can display the status of this function and other information with the
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Layer 3 functions
9.2 OSPFv2 (IPv4)
command.
no ASBR Router
show ip ospf
523