No Standby Force-Master; Standby Port - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.5 Ring redundancy and standby connection
Result
The standby force-master function is enabled.
Further notes
You disable the setting with the
You can display the status of this function and other information with the
redundancy
8.5.6.5

no standby force-master

Description
With this command, you disable the standby force-master function.
Requirement
● HRPis enabed
● You are in the Redundancy configuration mode.
The command prompt is:
cli(config-red)#
Syntax
Call the command without parameters:
no standby force-master
Result
The standby force-master function is disabled.
Further notes
You enable the setting with the
You can display the status of this function and other information with the
redundancy
8.5.6.6

standby port

Description
With this command, you configure and enable the port for a standby connection on a device.
482
no standby force-master
command.
standby force-master
command.
command.
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show ring-
show ring-