No Ipv6 Router Rip; Commands In The Ripng Router Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
Further notes
You disable routing with RIPng with the
You display the setting and other information with the
9.7.2.2

no ipv6 router rip

Description
With this command, you enable RIPng routing on the device.
Note
This command is available only with layer 3 (IPv6).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ipv6 router rip
Result
Routing with RIPng is disabled.
Further notes
You enable routing with RIP with the
You display the setting and other information with the
9.7.3

Commands in the RIPng Router configuration mode

This section describes commands that you can call up in the Router Configuration mode.
In the global configuration mode, enter the
mode.
696
no ipv6 router rip
show ipv6 rip
command.
ipv6 router rip
show ipv6 rip
command to change to this
ipv6 router rip
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.
command.