No Mac-Address-Table Aging-Time - Siemens SCALANCE XM-400 Configuration Manual

Load control
10.3 Dynamic MAC aging
Syntax
Call up the command with the following parameters:
mac-address-table aging-time <seconds(10-630)>
The parameter has the following meaning:
Parameter
seconds
Result
The value of the aging of a dynamically learned entry is configured.
Further notes
You can reset the setting to the default with the
You display the setting with the
10.3.2.2

no mac-address-table aging-time

Description
With this command, you reset the value for the aging of a dynamically learned entry in the
MAC address list to the default value.
The default value is 40 s.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no mac-address-table aging-time
Result
The value of the aging of a dynamically learned entry is reset to the default value.
790
Description
Life of the entry in seconds
show mac-address-table aging-time
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
10 ... 630
Default: 40
no mac-address-table aging-time
command.
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.