No Unicast-Block - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.2 Load and Save
Result
Unicast frames are blocked.
Further notes
You disable the blocking of unicast frames with the
You display the status of this function with
3.1.13.23

no unicast-block

Description
With this command, you disable the blocking of unknown unicast frames on an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no unicast-block
Result
The blocking of unicast frames is disabled.
Further notes
You enable the blocking of unicast frames with the
You display the status of this function with
108
no unicast-block
show unicast-block config
unicast-block
show unicast-block config
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
.
command.
.