Show Usage - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The unicast blocking settings for ports are displayed.
3.1.1.17

show usage

Description
With this command, you display the CPU and RAM usage as a percentage.
If the usage falls below or exceeds the displayed threshold values, the status changes
accordingly. With the
status change by a message.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show usage [{cpu|ram}]
The parameters have the following meaning:
Parameter
cpu
ram
If you do not specify any parameters, the usage of CPU and RAM is displayed.
72
Description
Keyword for a port description
Type or speed of the interface
Module no. and port no. of the interface
event config
or
cli#
Description
Display of the CPU usage and threshold
values
Display of the RAM usage and threshold
values
command, you can configure that you are informed of the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Range of values / note
-
Enter a valid interface
Range of values/note
-
-