Ipv6 Path Mtu - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.2 IPv6 protocol
Requirement
● The neighbor node is located on the same link.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ipv6 neighbor <prefix>
The parameter has the following meaning:
Parameter Description
prefix
IPv6 address of the neighbor node
vlan
Keyword for a VLAN connection
id
Number of the addressed VLAN
interface-type
Type or speed of the interface
interface-id
Module no. and port no. of the interface
MAC ADDRESS
Link layer address (MAC address) of the neighbor node
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The entry is deleted.
Further notes
You configure an entry with the
You display the IPv6 neighbor table with the
7.2.3.3

ipv6 path mtu

Description
With this command, you configure maximum packet size (MTU). The setting is only effective
if PMTU Discovery is enabled.
312
{vlan <id> | [<interface-type> <interface-id>]}
<MAC ADDRESS (xx:xx:xx:xx:xx:xx)>
command.
no ipv6 neighbor
show ipv6 neighbors
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Range of values / note
Enter a valid IPv6 address.
-
1 ... 4094
Enter a valid interface.
xx:xx:xx:xx:xx:xx
command.