No Ip Pim Bsr-Candidate - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.10 PIM (IPv4)
Syntax
Call up the command with the following parameters:
ip pim bsr-candidate <value (0-255)>
The parameter has the following meaning:
Parameter
value
Result
The interface is a candidate for the bootstrap router.
Further notes
You delete BSR candidates with the
You can display information about the selected bootstrap router with the
command.
9.10.5.2

no ip pim bsr-candidate

Description
With this command, you delete BSR candidates.
Requirement
● The interface is not a router port.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip pim bsr-candidate
Result
The interface is a candidate for the bootstrap router.
770
Description
Value for the priority
no ip pim bsr-candidate
Range of values / note
0 ... 255
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show ip pim bsr