Telnet-Server - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.1 IPv4 protocol
Note
This command is available only with layer 3.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip routing
Result
IPv4 routing is disabled.
Further notes
You enable the function with the
You display the setting with the
7.1.2.14

telnet-server

Description
With this command, you enable the Telnet server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
telnet-server
As default the function is "enabled".
300
command.
ip routing
command.
show ip route
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11