Http Server; The "Show" Commands; Show Ip Http Server Status; Commands In The Global Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Network protocols

7.10 HTTP server

7.10 HTTP server
This section describes commands of the Hypertext Transfer Protocol (HTTP).
7.10.1

The "show" commands

This section describes commands with which you display various settings.
7.10.1.1

show ip http server status

Description
This command shows the status of the HTTP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip http server status
Result
The status of the HTTP server is displayed.
7.10.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
420
or
cli#
command to change to this mode.
configure terminal
or
end exit
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command and are then in the