Show Mac-Address-Table Static Multicast - Siemens SCALANCE XM-400 Configuration Manual

Parameter
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The dynamic unicast MAC addresses are displayed.
6.1.1.4

show mac-address-table static multicast

Description
This command shows the table with the static multicast MAC addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show mac-address-table static multicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
or
cli#
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Network structures
6.1 VLAN
Range of values / note
-
-
-
Enter a valid interface
Range of values / note
-
1 ... 4094
-
-
-
Enter a valid interface
183