No Distribute-List Route-Map - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.6 RIPv2 (IPv4)
The parameters have the following meaning:
Parameter
name
in
out
Result
The filtering is enabled.
9.6.3.6

no distribute-list route-map

Description
This command disables the filtering of the routing information according to a route map for
incoming or outgoing routing information.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call up the command with the following parameters:
no distribute-list route-map <name(20)> {in | out}
The parameters have the following meaning:
Parameter
name
in
out
Result
The filtering is disabled.
682
Description
Name of the routing table.
Incoming routing information is filtered.
Outgoing routing information is filtered.
Description
Name of the routing table.
The filtering for incoming routing infor-
mation is disabled.
The filtering for outgoing routing infor-
mation is disabled.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
Maximum of 20 characters.
-
-
Range of values / note
Maximum of 20 characters.
-
-
Configuration Manual, 06/2016, C79000-G8976-C252-11