Vlan - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You enable the setting with the
You can display the status of this function and other information with the
info
6.1.2.9

vlan

Description
With this command, you create a VLAN on the device and change to the VLAN configuration
mode.
In the provider backbone bridge mode, this command is used to create user, service and
backbone VLANs.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameter
vlan-id
Do not enter any leading zeros with the number of the VLAN.
Result
The VLAN is created.
You are now in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Further notes
You delete the VLAN with the
You can display information about the VLAN with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
Description
Number of the addressed VLAN
command.
subnet-vlan
command.
no vlan
Network structures
show vlan device
Range of values / note
1 ... 4094
command.
show vlan
6.1 VLAN
197