The "Show" Commands; Show Ipv6 Ospf - Siemens SCALANCE XM-400 Configuration Manual

LSA types
Two new LSA types were defined for OSPFv3.
OSPFv2 OSPFv3
1 Router LSA 0x2001
2 Network LSA 0x2002
3 Summary 0x2003
LSA
4 AS Summary 0x2004
LSA
5 AS External 0x4005
LSA
7 NSSA Exter- 0x2007
nal LSA
0x2008
0x2009
In contrast to OSPFv2, OSPFv3 can forward unknown LSA types. Previously these were
deleted and not distributed further.
9.3.1

The "show" commands

This section describes commands with which you display various settings.
9.3.1.1

show ipv6 ospf

Description
This command shows information on routing via OSPFv3.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Who
Router every
LSA router
Network DR
LSA
Inter-area ABR
prefix LSA
Inter-Area ABR
Router
LSA
AS Exter- ASBR
nal LSA
Type 7 NSSA
LSA ASBR
Link LSA every
router
Intra area every
prefix LSA router
or
cli#
Within Description
Area No longer contains address information. This is contained in
the new LSA type 2009.
Area No longer contains address information. This is contained in
the new LSA type 2009.
Area Same function as in OSPFv2, simply renamed
Area Same function as in OSPFv2, simply renamed
AS Same function as in OSPFv2, simply renamed
NSSA Same function as in OSPFv2, simply renamed
Link The LSA is sent by the router to every router linked to it.
The LSA contains the link local address of the router and a
list with IPv6 prefixes configured on the link.
Area The LSA is sent only within an area. The LSA contains the
IPv6 prefixes connected to the router or network.
Layer 3 functions
9.3 OSPFv3 (IPv6)
567