Commands In The Global Configuration Mode; Route-Map - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.8 Route maps (IPv4 / IPv6)

Further notes

You create a route map and change to the Route maps configuration mode with the

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.

In Privileged EXEC mode, enter the

Commands relating to other topics that can be called in the Global configuration mode can

be found in the relevant sections.

You exit the Global configuration mode with the

Privileged EXEC mode again.

With this command you create a route map and change to the Route maps configuration

This command is available only with layer 3.

You are in the Global configuration mode.

The command prompt is as follows:

cli(config)#

Call up the command with the following parameters:

route-map <name(1-20)> [ {permit | deny }] [ <seqnum(1-10)> ]

The parameters have the following meaning:

Name of the route map

The routing information is further processed according to the

settings you make for the commands

command to change to this mode.

configure terminal

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

command and are then in the

Range of values / note