No Switchport Access Vlan - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
switchport access vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameter
vlan-id
Result
The Interface is added to the VLAN as an untagged port and the corresponding VLAN ID is
set.
Further notes
You can reset the setting to the default with the
You display the setting and other information with the
6.1.3.8

no switchport access vlan

Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport access vlan
Result
The setting is reset to the default value.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Number of the addressed VLAN
Range of values / note
1 ... 4094
no switchport access vlan
show vlan port config
Network structures
6.1 VLAN
command.
command.
205