Distribute-List - Siemens SCALANCE XM-400 Configuration Manual

9.3.3.10

distribute-list

Description
This command enables the filtering of the routing information according to a route map for
incoming routing information.
Note
This command is available only with layer 3.
Requirement
● OSPFv3 routing is activated.
● The router is an ASBR router.
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
distribute-list route-map <name(20)> in
The parameters have the following meaning:
Parameter
route-map
name
in
Result
The filtering is enabled.
Further notes
You disable the filtering with the
You enable OSPFv3 routing with the
You display the setting with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for a route map
Name of the route map
Incoming routing information is fil-
tered.
no distribute-list
ipv6 router ospf
show ipv6 ospf
Range of values / note
-
Maximum of 20 characters
-
command.
command.
command.
Layer 3 functions
9.3 OSPFv3 (IPv6)
591