Flow Control; The "Show" Commands; Show Flow-Control - Siemens SCALANCE XM-400 Configuration Manual

Load control

10.4 Flow control

Syntax
Call the command without parameters:
no mac-address-table aging
Result
The "Aging" function is disabled.
Further notes
You enable the "Aging" function with the
10.4 Flow control
The flow control function monitors the incoming data traffic of a port. If there is overload
("Congestion", "Overflow") it sends a signal to the connection partner. If the flow control
function receives a signal at the sending end, it stops the data transmission to avoid loss of
data.
This section describes commands of the flow control function.
10.4.1

The "show" commands

This section describes commands with which you display various settings.
10.4.1.1

show flow-control

Description
This command shows the settings of the flow control function.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show flow-control [interface <interface-type><interface-id>]
792
or
cli#
mac-address-table aging
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.