No Vrrp Associated-Ip - Siemens SCALANCE XM-400 Configuration Manual

9.5.5.4

no vrrp associated-ip

Description
With this command, you remove an IP address from the virtual router.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> associated-ip [{ ipv4 <ip_addr> | ipv6 <ip6_addr> }]
The parameters have the following meaning:
Parameter
vrid
ipv4
ip_addr
ipv6
ip6_addr
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IP address is removed from the virtual router.
Further notes
You configure a VRRP3 interface with the
You display the IP addresses with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
ID of the virtual router
Keyword for IPv4 address
IPv4 address
Keyword for IPv6 address
IPv6 address
interface
show vrrp
9.5 VRRPv3 (IPv4 / IPv6)
Range of values / note
1 ... 255
-
Enter a valid IPv4 address.
-
Enter a valid IPv6 address.
command.
command.
Layer 3 functions
663