Vrrp Associated-Ip - Siemens SCALANCE XM-400 Configuration Manual

Note
The commands are only available with layer 3 and only in conjunction with VLAN interfaces.
In the VRRP Router configuration mode, enter the
mode.
Commands relating to other topics that can be called in the Interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
VRRP Router configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
9.4.4.1

vrrp associated-ip

Description
With this command, you specify which IPv4 addresses the virtual router monitors.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> associated-ip <ip_addr>
The parameters have the following meaning:
Parameter
vrid
ip_addr
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
ID of the virtual router
Value for an IPv4 address
command to change to this
interface
command, you return to the
exit
command, you return to the
end
Range of values / note
1 ... 255
Enter a valid IPv4 address.
Layer 3 functions
9.4 VRRPv2 (IPv4)
631