No Client Config; Event Config - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

no client config

With this command, you disable one of the clients that processes or forwards the messages

of the device.

You are in the EVENTS Configuration mode.

The command prompt is as follows:

cli(config-events)#

Call up the command with the following parameters:

no client config {syslog|trap|email|all}

The parameters have the following meaning:

The client selected for the transfer is disabled.

Further notes

You display the status of the events and the clients with the

You enable the function with the

With this command, you configure which of the various message types of the device will be

stored or forwarded.

The following events or message types are available:

● Message if there is cold or warm restart

● Message when there is a status change on a physical interface

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Disables the client that sends the messages to the Syslog server

Disables the client that sends the SNMP traps

Disables the client that sends the e-mails

Disables all clients at once

client config

12.1 Event and fault handling

show events config