Redist-Config - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf passive-interface
Result
The configuration is active.
Further notes
You enable the configuration with the passive-interface command.
You can display the status of this function and other information with the
interface
9.3.3.16

redist-config

Description
With this command, you configure the information for external routes. The routes are further
distributed with this information
Note
This command is available only with layer 3.
Requirement
● The router is an ASBR router.
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
596
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show ipv6 ospf