No Ipv6 Mld Snooping; Ipv6 Mld Snooping Clear Counters - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.8 MLD Snooping (IPv6)
8.8.2.4

no ipv6 mld snooping

Description
With this command, you disable MLD snooping on the device or on the required VLAN.
Requirement
You are in the Global configuration mode or in the VLAN configuration mode.
The command prompt is in the Global configuration mode is:
cli(config)#
or in the VLAN configuration mode:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ipv6 mld snooping
Result
MLD snooping is disabled.
Further notes
You enable MLD snooping with the
8.8.2.5

ipv6 mld snooping clear counters

Description
With this command, you reset the counters of the MLD snooping statistics to zero.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ipv6 mld snooping clear counters [Vlan <vlanid (1-4094)>]
504
command.
ipv6 mld snooping
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11