No Switchport Private-Vlan Mapping - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
Requirement
● The interface is configured as a promiscuous port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport private-vlan mapping <primary_vlan_id(1-4094)> [{add | remove}]
[<secondary_vlan_list>]
The parameters have the following meaning:
Parameter
primary_vlan_id
add
remove
secondary_vlan_list
Result
The interface is configured.
Further notes
You delete the configuration with the
You display this setting and other information with the commands
show vlan
You configure the interface as a promiscuous port with the
6.1.3.19

no switchport private-vlan mapping

Description
With this command, you delete the configuration of a promiscuous port.
214
Description
VLAN ID of the primary PVLAN
Adds secondary PVLANs.
Removes secondary PVLANs.
VLAN ID of the secondary PVLAN
and
show vlan private-vlan
no switchport private-vlan mapping
.
switchport mode
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Range of values / note
1 ... 4094
-
-
1 ... 4094
Separate the PVLANs with
commas if you specify
several PVLANs.
command.
,
show vlan port config
command.