No Ip Dhcp Relay Circuit-Id; Ip Dhcp Relay Remote-Id - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.6 DHCPv4 Relay Agent (IPv4)
Result
The Circuit ID is assigned.
Further notes
You remove the Circuit ID with the
You display the IP addresses with the
You display the settings with the
7.6.3.2

no ip dhcp relay circuit-id

Description
With this command, you remove the Circuit ID.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip dhcp relay circuit-id
Result
The Circuit ID is removed.
Further notes
You configure the Circuit ID with the
You display the IP addresses with the
You display the settings with the
7.6.3.3

ip dhcp relay remote-id

Description
With this command, you specify the device ID.
374
no ip dhcp relay circuit-id
show dhcp server
show ip dhcp relay information
ip dhcp relay circuit-id
show dhcp server
show ip dhcp relay information
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.
command.
command.
command.
command.