Mac-Address-Table Static Multicast - Siemens SCALANCE XM-400 Configuration Manual

Load control
10.2 Static MAC filtering
Syntax
Call up the command with the following parameters:
mac-address-table block static multicast<aa:aa:aa:aa:aa:aa>vlan<vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
-
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The static multicast MAC address is configured.
Further notes
You delete the static multicast MAC address with the
multicast
10.2.1.2

mac-address-table static multicast

Description
With this command, you generate a static multicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
782
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
command.
Range of values / note
aa:aa:aa:aa:aa:aa
-
1 ... 4094
no mac-address-table static
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11