System Contact - Siemens SCALANCE XM-400 Configuration Manual

The parameters have the following meaning:
Parameter
off
on
Result
PROFINET is enabled or disabled after the next restart.
Further notes
You display the current PROFINET configuration with the
You restore the default settings of the PROFINET profile with the
3.1.12.10

system contact

Description
With this command, you enter contact information for the system.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
system contact <contact info>
The parameter has the following meaning:
Parameter
contact info
Result
The contact information is created in the system.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
PROFINET is disabled.
PROFINET is activated.
Description
Input box for contact information
Range of values / note
If a PROFINET connection is established; in
other words the PROFINET AR status is
"Online", you cannot disable PROFINET.
When PROFINET is turned on, EtherNet/IP
is turned off. The switchover from
PROFINET and EtherNet/IP has no effect on
DCP.
command.
show pnio
command.
restart
Range of values / note
max. 255 characters
Configuration
3.1 System
89