Panel-Button Control-Factory-Defaults; No Panel-Button Control-Factory-Defaults - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

panel-button control-factory-defaults

With this command, you enable the following function of the "SELECT/SET" button:

● When display mode A "port status" is displayed, and the button is pressed for more than

12 seconds, there is a restart with the factory settings.

You are in the Global configuration mode.

The command prompt is as follows:

cli(config)#

Call the command without parameter assignment:

panel-button control-factory-defaults

The function of the "SELECT/SET" button for restarting with factory settings is enabled.

Further notes

You disable this function with the

With this command, you disable the following function of the "SELECT/SET" button:

● When display mode A "port status" is displayed, and the button is pressed for more than

12 seconds, there is a restart with the factory settings.

You are in the Global configuration mode.

The command prompt is as follows:

cli(config)#

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

no panel-button control-factory-defaults

Functions specific to SCALANCE

4.3 Panel button