Layer 3 functions
9.9 NAT (IPv4)
Syntax
Call the command without parameter assignment:
show ip nat config
Result
The global NAT configuration is displayed.
Further notes
You enable NAT/NAPT for the entire device with the
configuration mode.
You disable NAT/NAPT for the entire device with the
configuration mode.
You delete the periods of time with the
You can reset the time periods to the default with the
9.9.1.2
show ip nat service
Description
This command shows static port translations (NAPT) for an interface with a service.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ip nat service
Result
The information is displayed.
Further notes
You configure static port translations for an interface with the
You delete a configuration with the
736
or
cli#
ip nat
no ip nat
command.
ip nat timeout
ip nat timeout
command.
no ip nat service
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command in the Global
command in the Global
command.
command.
ip nat service