Commands In The Global Configuration Mode; Ip Nat - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You configure a static address translation with the
You delete a static address translation with the
You configure a dynamic address translation with the
You delete a dynamic address translation with the
9.9.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
9.9.2.1

ip nat

Description
With this command you enable NAT/NAPT for the entire device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip nat
Result
NAT/NAPT is enabled globally for the entire device. The device operates as a NAT router.
Further notes
You disable NAT/NAPT for the entire device with the
You display the current configuration with the command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
ip nat static
no ip nat static
ip nat pool
no ip nat pool
command to change to this mode.
configure terminal
or
end exit
no ip nat
Layer 3 functions
9.9 NAT (IPv4)
command.
command.
command.
command.
command and are then in the
command.
739