Match Destination Ipv6 - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
Syntax
Call up the command with the following parameters:
no match destination ip <Ip address> <Net Mask>
The parameters have the following meaning:
Parameter
Ip address
Net Mask
Result
The filter for the destination IPv4 address is deleted.
Further notes
You create a filter for the destination IPv4 address with the
You create a filter for the destination IPv6 address with the
command.
You change to the Route maps configuration mode with the command
You display the setting and other information with the
9.8.3.3

match destination ipv6

Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the destination IPv6 address.
Note
This command is available only with layer 3 (IPv6).
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
714
Description
IPv4 address
Subnet mask of the corresponding
subnet
Range of values / note
Enter the IPv4 address of the destination on which the filter-
ing is based.
Enter the subnet mask of the destination on which the filter-
ing is based.
match destination ip
match destination ipv6
show route-map
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
.
route-map
command.