Match Route-Type - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
9.8.3.15

match route-type

Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the type of the route.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Syntax
Call up the command with the following parameters:
match route-type {local | remote }
The parameters have the following meaning:
Parameter
local
remote
Result
The filter for the type of the route is created.
Further notes
You delete the filter for the type of the route with the
You change to the Route maps configuration mode with the command
You display the setting and other information with the
726
Description
Directly connected routes (local interfaces)
Learnt or statically configured routes
Range of values / note
-
-
no match route-type
show route-map
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
.
route-map
command.