Switchport Map Protocols-Group - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
Further notes
You configure the setting with the
You can display the status of this function and other information with the
config
6.1.3.9

switchport map protocols-group

Description
With this command, you assign the protocol group and a VLAN to an interface.
Requirement
● The protocol group is configured.
● You are in the Interface configuration mode
.The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport map protocols-group
The parameters have the following meaning:
Parameter
group id
vlan
vlan-id
Result
The group is assigned to the port and the VLAN.
Further notes
You delete the setting with the
You can display the status of this function and other information with the
protocols-group
206
command.
<group id(0-2147483647)>vlan<vlan-id(1-4094)>
Description
Number of the group
Keyword for a VLAN connection
Number of the addressed VLAN
command.
switchport access vlan
no switchport map protocols-group
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
show vlan port
Range of values / note
0 ... 2147483647
-
1 ... 4094
command.
show vlan