No Rp-Candidate Rp-Address - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.10 PIM (IPv4)
The parameters have the following meaning:
Parameter
Group Address
Group Mask
IP address
Priority
Result
The interface is a candidate for the rendezvous point.
Further notes
You delete RP candidates with the
You display the interface candidates for rendezvous points with the
candidate
9.10.4.2

no rp-candidate rp-address

Description
With this command, you delete RP candidates.
Requirement
You are in the PIM configuration mode.
The command prompt is as follows:
cli(router-pim)#
Syntax
Call up the command with the following parameters:
no rp-candidate rp-address <Group Address> <Group Mask> <RP address>
766
Description
Address of the multicast group for
which the interface will become
RP.
Subnet mask that restricts the
multicast band
IP address of the interface that will
become RP
Priority of the interface
command.
Range of values / note
-
-
-
0 ... 255
Default: 192
no rp-candidate rp-address
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
show ip pim rp-