Show Interfaces Etherchannel - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.2 Link aggregation
Syntax
Call up the command with the following parameters:
show etherchannel [[channel-group-number]
The parameters have the following meaning:
Parameter
channel-group-
number
detail
load-balance
port
port-channel
summary
protocol
If you do not select any parameters from the parameter list, the settings of all channels will
be displayed in detail.
Result
The Etherchannel settings are displayed.
6.2.1.2

show interfaces etherchannel

Description
This command shows the interface-specific information for a port channel.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show interfaces[<interface-type><interface-id>]etherchannel
The parameters have the following meaning:
Parameter
interface-type
interface-id
228
{detail|load-balance|port|port-channel|summary|protocol}]
Description
Number of the Channel-Group
Detailed display of the settings
Shows which load balancing method is enabled
Information on the Etherchannel port
Information on the Port-Channel
Brief overview of the settings of a Channel-Group
Specification of the protocol set for a Channel-Group
or
cli#
Description
Type or speed of the interface
Module no. and port no. of the interface
Range of values / note
Enter a valid interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11