Redistribute - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.2 OSPFv2 (IPv4)

You are in the OSPF Router configuration mode.

The command prompt is as follows:

cli(config-ospf)#

Call up the command with the following parameters:

no redist-config <Network> <Mask>

The parameters have the following meaning:

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

The information for the route is deleted.

Further notes

You create the information with the

redistribute

With this command, you specify which known routes are distributed via OSPF.

This command is available only with layer 3.

● The router is an ASBR router.

● You are in the OSPF Router configuration mode.

The command prompt is:

cli(config-ospf)#

Target address of the route.

Subnet mask of this route

redist-config

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Range of values / note

specify the IP address.

specify the subnet mask.

Configuration Manual, 06/2016, C79000-G8976-C252-11