Show Ip Pim Interface Detail - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.10 PIM (IPv4)
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip pim rp-hash [<multicast_Group_address> <Group_mask>]
The parameters have the following meaning:
Parameter
mul-
ticast_Group_addres
s
Group_mask
If no parameters are specified, the RPs of all multicast groups are displayed.
Result
The current rendezvous point of the multicast group is displayed.
Further notes
You define interfaces as candidates for rendezvous points with the command
rp-address
You configure a device as a static rendezvous point with the
You specify the interfaces for static rendezvous points with the
command.
9.10.1.2

show ip pim interface detail

Description
With this command, you display detailed settings for PIM.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
754
or
cli#
Description
Address of the multicast group
Subnet mask that restricts the multicast
band
.
or
cli#
Range of values / note
-
-
ip pim static-rp
rp-static rp-address
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
rp-candidate
command.