No Router Vrrp3 - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
Result
Routing with VRRP3 is enabled.
You are now in the VRRP3 Router configuration mode.
The command prompt is as follows:
cli (config-vrrp-v3)#
Further notes
You disable routing with VRRP with the
You enable IPv6 routing with the
You configure an IPv6 address for the interface with the
9.5.3.2

no router vrrp3

Description
With this command, you disable routing with VRRPv3.
Note
This command is available only with layer 3.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no router vrrp3
Result
Routing with VRRPv3 is disabled.
Further notes
You enable routing with VRRPv3 with the
650
no router vrrp3
command.
ipv6 unicast-routing
command.
router vrrp3
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.
ipv6 address