No Ip Ospf Retransmit-Interval - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
Result
The interval is specified.
Further notes
You delete the interval with the
9.2.4.14

no ip ospf retransmit-interval

Description
With this command, you delete the interval.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ip ospf retransmit-interval
Result
The interval is deleted.
Further notes
You configure the interval with the
You configure the router port with the
562
no ip ospf retransmit-interval
ip ospf retransmit-interval
command.
no switchport
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.