No Redistribute; Version - Siemens SCALANCE XM-400 Configuration Manual

Result
The information forwarded by RIP has been specified.
9.6.3.10

no redistribute

Description
This command specifies which route information is not forwarded by RIP.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call up the command with the following parameters:
no redistribute {all | default | connected | ospf | static} [route-map <name(20)>]
The parameters have the following meaning:
Parameter
all
default
connected
ospf
static
route-map
name
Result
In certain cases, forwarding of routing information is disabled.
9.6.3.11

version

Description
With this command, you specify which version the RIP protocol uses to send and receive
routing information.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
The forwarding of route information is
disabled for all protocols.
Default routes are not forwarded.
Route information of local subnets is
not forwarded.
No routes learned by OSPF are dis-
tributed.
No static routes are forwarded.
Keyword for a route map.
Name of the route map.
Layer 3 functions
9.6 RIPv2 (IPv4)
Range of values / note
-
-
-
-
-
-
Maximum of 20 characters
685