Show Ip Pim Rp-Candidate; Show Ip Pim Rp-Set - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.10 PIM (IPv4)
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all interfaces are displayed.
Result
The current PIM neighborhood table is displayed.
Further notes
You enable PIM globally on the device with the
9.10.1.4

show ip pim rp-candidate

Description
With this command, you display the interfaces of the device that are candidates for
rendezvous points.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ip pim rp-candidate
Result
The interfaces of the device that are candidates for rendezvous points are displayed.
Further notes
You specify the interface candidates for rendezvous points with the
command.
9.10.1.5

show ip pim rp-set

Description
With this command, you display all rendezvous points of the network.
756
or
cli#
command.
ip pim routing
rp-candidate rp-address
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11