Commands In The Interface Configuration Mode; Ipv6 Dhcp Authentication Client - Siemens SCALANCE XM-400 Configuration Manual

7.4.2

Commands in the Interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
7.4.2.1

ipv6 dhcp authentication client

Description
With this command, you configure the HMAC-MD5 function for authentication of DHCP
messages.
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp authentication client {realm <string(1-128)> | key <string (1-64)> | keyid
<value>}
The parameters have the following meaning:
Parameter
realm
string
key
string
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for the name of the database area
Name of the database area in which the pass-
word for the HMAC algorithm MD5 is stored
Keyword for the password
Password for the HMAC algorithm MD5
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
Range of values / note
-
Enter a name.
1 ... 128
-
Enter a valid password.
1 ... 64
Network protocols
7.4 DHCPv6 client (IPv6)
337