Ip Route - Siemens SCALANCE XM-400 Configuration Manual

Parameter
index
id
Result
The required DNS server was deleted.
7.1.2.10

ip route

Description
With this command, you configure a static entry in the IP routing table.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip route <prefix> <mask> <next-hop> [<distance(1-255)>]
The parameter has the following meaning:
Parameter
prefix
mask
next-hop
distance
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The entry in the IP routing table is configured.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for the index
Index of the DNS server
Description
Specifies the IP address or the address
range
Specifies the subnet mask used for
.
prefix
Use decimal notation.
Specifies the IP address to which the
selected addresses will be forwarded.
The value for the administrative dis-
tance.
Network protocols
7.1 IPv4 protocol
Range of values / note
-
1 ... 3
Range of values / note
specify a valid IP address
enter a valid subnet mask
specify a valid IP address
1 ... 255
297